wrench holders

The wrench holders are based around these holders

The holders are bolted to the rear beam above the work bench. There is an acrylic piece used to identify the wrenches for organization. Inserted into the organizer are 3d printed spacers to keep even spacing and make sure the wrenches are lined up with the ID card. 


Attached to this page are a few files
1. Some STL files of spacers to keep the wrenches evenly spaced. 
2. The DXF files for the acrylic ID plates that go behind them
3. The fusion files if you need to make new ones or change something. 
Comments